Categories
General Multi-Rotors

Hovership Micro H-Quad Review

So a while ago I came across this cool looking 3D printed quad frame from hovership.  When I was looking to do another quad build and after the success of my other 3D printed frame I decided to order it and start my next quad build. I have had it build and have flown it […]

So a while ago I came across this cool looking 3D printed quad frame from hovership.  When I was looking to do another quad build and after the success of my other 3D printed frame I decided to order it and start my next quad build. I have had it build and have flown it for over or close to a month now and decided to review it for the hovership site. Below is my review of the quad frame so far but before that a few videos of my FPV flights.

These are my two most recent videos. I have a long way to go until I fly at the level as many other flyers on YouTube, but my skill seem to be improving. I have a few more videos on my page as well as some flights from my other quad. My thoughts on the quad are as follows.

3D Printed Foldable Awesomeness

IMG_3103

The MHQ was my second build of a multi-rotor and my second purchase of a 3D printed frame. The quality of the 3D parts are great and with the included accessories it all comes together nicely and feels very sturdy. It has been a great flier for me since I built it a few weeks ago, I do however have two issues with it.

IMG_3079

The first is the legs that are included with the kit are not that strong unless you have perfect landings all the time. As another reviewer has noted they are a bit weak and broke for me on my second set of flights. Since then I have broken all the legs off with the middle section still screwed on. Also the antenna mounting plate broke as well so I just zip tie the antenna to the camera deck now.

IMG_3098My second issue is the vibration dampeners while awesome and a great way to separate parts of the quad, where impossible for me to pull through the flight controller deck. It could be my 12amp T-motor ESC’s are just to thick but I could not push them through. I could get one or two on the edges maybe but the rest where not going through. In the end I just zipped tied the two together with the dampeners in between to keep it all together and it flies well.

IMG_3100

After a few weeks of flying it has survived all the crashes I have put it through. The best thing for me so far has been the fordable arms. I have on many occasions clipped branches and fences and gone down only to find a dirty quad with an arm or two pushed in. They also make it handy for traveling. The only part that has seen any real damage is a small chip on the front arm plate from me going head first into a fence. (I was trying to pull up.)

IMG_3108

Overall I have to say I’m very happy with my quad so far, it’s size and fold-ability has been a real plus for me. The guides help a new builder like me to put it together with no issues at all minus having to use some extra screw to mount the motors. I made a short build log on the flite test forums with videos and some of my fpv flights (new flier alert!) on my YouTube channel G2BPro. I would recommend this frame for any one looking to get good durable frame at a reasonable price.

IMG_3102

My Build:

MHQ Frame
12amp T-motor ESC’s
RCX 1804 Motors
Acro naze 32
JST to XT60 distribution cord
micro spektrum compatible dsm2 receiver
altitude rc transmitter
5.8 GHz SpiroNET Omni Antenna
RMRC-MINI-V2